Qlab osc go8/9/2023 ![]() ![]() There doesn't seem to be any correlation between time between cues and this error, so some kind of network timeout doesn't seem likely Going back (up arrow) in qlab retaking the skipped cue will cause it to successfully trigger. Older MacPro running QLab, two new trashcan MacPros running Resolume ![]() In our show of 70 cues (213 total counting autofollows and grouped triggers), a cue will be dropped on average once every other show. For example, a cue triggering Column X on server #1 and an autofollow without a delay to a similar cue on server #2 - It seems to only happen when I have multiple cues tied together.However, intermittently we have had dropped cues. Due to the large nature of the show we split the composition into one server handing the video wall and one handling front projection. ![]() I'm using QLab4 which is sending OSC cues to two separate Resolume servers. ![]() You’ll need to install a license in order to use this cue.Bit of a mind bender here and was wondering if anyone has had encountered a similar situation. A license is required to reactivate this saved cue. This is only relevant for OSC cues set to the Raw UDP string type. No UDP message specified.įill in a valid UDP string in the Settings tab of the inspector. This is only relevant for OSC cues set to the Custom OSC message type. Invalid OSC message.įill in a valid OSC message in the Settings tab of the inspector. No OSC message specified.įill in a valid OSC message in the Settings tab of the inspector. This is only relevant for OSC cues set to the QLab OSC message type. Invalid command parameters.įill in valid parameters in the Settings tab of the inspector. Missing QLab cue number.įill in a valid cue number in the Settings tab of the inspector. You may also need to visit the OSC section of Settings and specify a valid destination address and port for the desired patch. OSC cues can become broken for the following reasons: Invalid network destination.Īssign a valid network destination in the Settings tab of the inspector. Click this button to test-send your message. Some software, such as Medialon Manager, can accept commands as plaintext strings over UDP, and while this isn’t technically OSC, we use the OSC cue as the place to achieve this. This option allows you to send strings over UDP which will not be encoded as OSC by QLab on the way out. That sends message message to address /my/groovy with three integers, 2, 10, and 12, as separate arguments. Multiple arguments in a custom OSC message are separated by spaces, like this: For example, to tell a remote copy of QLab to GO, enter the command /go. This option gives you a text field to enter any OSC command. Enter a cue number below, and choose a command to send to the remote copy of QLab. For convenience when using OSC cues to communicate with another computer running QLab, this option provides a very simple interface for sending several commonly used commands. Select which type of message you want to send. This drop-down menu shows the sixteen OSC patches, or destinations, to which QLab can send OSC messages. Please refer to the section on the inspector in the Getting Started section of this documentation. When an OSC cue is selected, two tabs will appear in the Inspector: OSC cues allow QLab to send messages using the Open Sound Control protocol a flexible, extensible, network-based messaging system designed as a sort of successor to MIDI. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |